System Setup and Configuration for Novell NetWare 5.1
Creating Novell Storage Service Volumes
To create NSS volumes to be used in the cluster:
1. Type NWCONFIG from the system console.
2. Select NSS Disk Options, Storage, Assign Ownership.
3. Select one logical unit (LUN ) at a time and click Yes to initialize.
4. Repeat steps 2 and 3 for each shared LUN. Exit the utility.
5. Type NWCONFIG from the system console.
6. Select NSS Disk Options, NSS Volume Options, Create, NSS Volume.
7. Select a LUN and give the LUN a name.
8. Click Yes.
NOTE: You should receive a message that reads Successfully created the
new NSS Volume and added it to NDS.
9. Repeat steps 7 and 8 for each LUN.
To configure the second server to see the NSS volumes:
1. Type NWCONFIG from the second server system console.
2. Select NSS Disk Options, Storage, Update Provider Information.
3. Update both the GSEG (Group/Segment Manager) and the MMPRV (NSS Media
Manager Provider). Exit the utility.
4. Type NSS volumes from the command console on each server to verify that
the servers recognize the volumes.
5-6 HP ProLiant DL380 Generation 3 Packaged Cluster Setup and Installation Guide
HP CONFIDENTIAL Codename: Sopwith Part Number: 252261-002 Last Saved On: 11/8/02 2:57 PM
To Next Page
Loading...
Need help?
General