HP SN6000B 16Gb 48-port
Fibre Channel Switch and
Rack Mount Kit Quick Start
Instructions
© Copyright 2011 Hewlett-Packard Development Company, L.P.
Printed in the U.S.
*5697-1156*
HP Part Number: 5697-1156
Published: September 2011
Edition: 2
Overview
Read these instructions to set up and configure the HP
SN6000B 16Gb Fibre Channel Switch.
These instructions provide basic configuration steps.
For detailed rack mount and configuration instructions,
download the HP SN6000B 16Gb 48-port Fibre
Channel Switch Hardware Reference Guide from the
storage section of the HP website: http://
www.hp.com/support/manuals.
Figure 1 (page 1) shows the port side of the switch.
Figure 1 Port side of the SN6000B 16Gb FC Switch
6. FC ports (44–47)1. System status LED
7. FC ports (4–7)2. Management Ethernet port
with LEDs
8. Switch ID pull-out tab3. USB port
9. Serial console port4. FC ports (0–3)
10. System power LED5. FC ports (40–43)
Verify the carton contents
Verify that the carton contains the following (any SFPs
ordered will not be in this carton; they will be
packaged separately):
• One HP SN6000B 16Gb FC Switch with two
integrated power supply/fan assemblies
• One accessory kit with the following items:
Serial cable with an RJ-45 connector◦
◦ Two 6-foot power cords
◦ Rubber feet, required to set up the switch as
a standalone unit
◦ Rack Mount Kit, including rails, rail mounting
hardware, and plenum
Page 1
To Next Page
Need help?
General