HP SN6000B User Manual

1. Enter the switchshow command to verify the switch mode.
AG Mode is displayed if the switch is in AG mode. Interopmode 0 or Native is displayed if
the switch is in Native mode.
2. Enter the switchdisable command to disable the switch.
The switch must be disabled in order to enable or disable AG mode.
3. Enter the ag --modeDisable command to disable AG mode.
4. Enter the ag --modeshow command to verify that AG mode is disabled.
switch:admin> ag --modeshow
nl
Access Gateway mode is NOT enabled
Disabling and enabling AG mode 27

HP SN6000B Specifications

General

Brand	HP
Model	SN6000B
Category	Switch
Language	English