2. Ensuring that the rail-bracket shelf (2) is engaged by the lip on the underside of the tray (3), slide
the assembly into position in the rack.
Figure 5 Loading the workstation into the rack
3. Secure the assembly into the rack by tightening the silver captive screws (1).
Figure 6 Completing installation
NOTE: To remove the assembly from the rack, loosen the silver captive screws (1), and then pull
the handle to slide the assembly out of the rack until the latches in the tray (2) engage the stop
feature. Reach under the assembly and release the latches (2) to disengage the tray from the rails.
CAUTION: For removal, the workstation must be supported once the latches are disengaged.
6 Rack mount tray installation ENWW
To Next Page
Loading...
Need help?
General
