Rack considerations
Before beginning these procedures, be sure you understand and follow these precautions:
WARNING! To reduce the risk of personal injury or damage to the equipment be sure that:
● The leveling jacks are extended to the floor.
● The full weight of the rack rests on the leveling jacks.
● The stabilizing feet are attached to the rack if it is a single-rack installation.
● The racks are coupled in multiple-rack installations.
● Only one component is extended at a time. A rack may become unstable if more than one
component is extended for any reason.
Installing the depth-adjustable fixed rails rack
option kit
1. Loosen the wing nuts (1) and extend the brackets to the desired length (2) for each depth-
adjustable fixed rail.
2. Tighten the wing nuts slightly to stabilize the brackets during installation.
3. Beginning at the front of the rack, use the top screw holes for initial placement of the depth-
adjustable fixed rails. These screws may have to be moved later to correctly install the component.
ENWW Rack considerations 9
To Next Page
Loading...
Need help?
General
