1
HP zl2 Module Quick Setup Guide
The module drawings in this document are for illustration purposes only and may not match your module.
1. Load the most current switch software that
supports your module. See Speci
fications.
2. Prepare for installation
To avoid personal injury or product damage, review the
“Installation precautions” on page 2.
3. Install the modules into a switch slot
The switch can be either powered on or off.
2 Open extractor handles
Close the extractor handles to seat the
module, and tighten the retaining
screws until just snug.
1 Insert module into the
guides and slide it in until
it is fully inserted.
4. Install optional transceivers
mini-GBIC or SFP
transceiver or SFP+
Warning: Avoid direct eye exposure to the beam
coming from the transmit port.
5. Verify self-test
1 Fault and Test LEDs = Off
2 Module Status LEDs = On
6. Connect network cables
7. Verify network connections
See the Ins
tallation and Getting Started Guide for your
module. For example, a module with a standard RJ-45 LAN
port is illustrated in the following illustration.
Note: Operation of each port’s Link and Mode
LEDs depends on the switch’s Mode selection.
For information on LED behavior, see the HP
5400R zl2 Installation and Getting Started Guide.
8. (Optional) Customize the configuration for the
modules’ ports
If the default port configuration is not appropriate for your
ne
twork application, configure the port(s) in the module by
using the switch console or the web browser interface. See
the HP 5400R zl2 Installation and Getting Started Guide for
information about connecting a console, and see the
Management and Configuration Guide for information
about configuring the switch and its ports.
For module documentation, go to the HP Networking website
at:
www.hp.com/networking/support.
Auto search on “zl modules,” and sel
ect your module from the
list. Click Display selected, and then click on the links that
have Manuals listed to get on to the webpage that lists the
available manuals.
zl Module-QSG.fm Page 1 Thursday, February 27, 2014 1:31 PM
To Next Page
Need help?
General
