HTW HTW-RG52 User Manual

Model
Rated Voltage
8m (when using 3.0 voltage, it gets 11m)
3.0V(Dry batteries R03/LR03×2)
Remote Controller Specifications
1. Operating Mode: AUTO, COOL, DRY, HEAT(Cooling only model without),
and FAN.
2. Timer Setting Function in 24 hours.
。 。
3. Indoor Setting Temperature Range : 17 C~30 C.
4. Full function of LCD (Liquid Crystal Display).
Environment
Signal Receiving
Range
Performance Feature
3 4
RG52C1/BG(C)E.
。 。
-5 C 60 C
~
ON/OFF
MODE
FAN
SLEEP
TEMP
SHORT
CUT
TIMER ON
TIMER OFF
SWING DIRECT
Buttons design might be slightly different
from the actual one you purchased depending
on individual models.
All the functions described are accomplished
by the indoor unit. If the indoor unit has no this
feature, there is no corresponding operation
happened when press the relative button on
the remote controller.
NOTE:
Function buttons
1
2
Each time the button is pressed, the operation
mode is selected in a sequence of following:
3
MODE Button
4
5
ON/OFF Button
Operation starts when this button is pressed
and stops when this button is pressed again.
NOTE: Heat mode is for Cooling & Heating models only.
AUTO COOL
DRY HEAT FAN
TIMER ON Button
6
UP Button( )
Push this button to decrease the indoor
o
temperature setting in 1 C increments
o
to 17 C.
DOWN Button( )
Used to select the fan speed in four steps:
AUTO LOW MED HIGH
FAN Button
Press this button to initiate the auto-on time
sequence. Each press will increase the
auto-timed setting in 30 minutes increments.
When the setting time displays 10, each
press will increase the auto-timed setting 60
minutes increments. To cancel the auto-timed
program, simply adjust the auto-on time to 0.0.
1
2
4
3
5
10
6
7
8
9
ON/OFF
MODE
FAN
TEMP
SHORT
CUT
TIM ER ON
TIM ER OFF
SLEEP SWING DIRECT
SLEEP Button
NOTE: While the unit is running under SLEEP
mode, it would be cancelled if MODE, FAN
SPEED or ON/OFF button is pressed.
Active/Disable sleep function. It can maintain
the most comfortable temperature and save
energy. This function is available on COOL,
HEAT or AUTO mode only .
Push this button to increase the indoor
o
temperature setting in 1 C increments
o
to 30 C.

HTW HTW-RG52 Specifications

General

Brand	HTW
Model	HTW-RG52
Category	Remote Control
Language	English