Buttons and Functions
Before you begin using your new air conditioner, make sure to familiarize yourself with its remote
control. The following is a brief introduction to the remote control itself. For instructions on how to
operate your air conditioner, refer to the How to Use Basic Functions
section of this manual.
ON/OFF
SET
Turns the unit on or off.
MODE
OK
TIMER
CLEAN
LED
Turbo
ECO/GEAR
Scrolls through operation modes
as follows:
AUTO
COOL
DRY
HEAT FAN
FAN SPEED
SWING
Model:
NOTE: For models of RG10A3(F1/H1/G1)/BGEFU1 and RG10A3(F1/H1/G1)/BGCEFU1, press
together & buttons at the same time for 3 seconds will alternate the temperature display
between the °C & °F scale. Fresh feature is only available for for models of
RG10A2(F/H/G)/BGCEF and RG10A10(F/H/G)/BGEF.
TEMP
TEMP
04
RG10A3(F/H/G)/BGEF, RG10A3(F1/H1/G1)/BGEFU1,
RG10A2(F/H/G)/BGCEF and RG10A3(F1/H1/G1)/BGCEFU1(Cooling only models,
AUTO mode and HEAT mode are not available),
RG10A10(F/H/G)/BGEF(20-28 C).
Used to confirm the
selected functions.
O
Starts and stops the horizontal
louver movement. Hold down
for 2 seconds to initiate vertical
louver auto swing feature
(some units).
Set timer to turn unit on or off
Press this button to enter the
energy efficient moce in a
sequence of following:
ECO GEAR(75%)
GEAR(50%)
mode ECO
......
Sleep( )
Fresh...
Follow Me( )
AP mode( )
Enables unit to reach preset
temperature in shortest possible
time.
Previous setting
Selects fan speeds in the
following order:
AUTO LOW MED HIGH
NOTE: Holding this button
down for 2 seconds will
activate Silence feature.
SHORTCUT
Used to restore the current
settings or resume previous
settings.
Increases temperature
O O
in 1 C(1 F) increments.
Max. temperature is
O O
30 C(86 F).
Decreases temperature
O O
in 1 C(1 F) increments.
Min. temperature is
O O
17 C(62 F).
Scrolls through operation
functions as follows:
Fresh( )
The selected symbol will
flash on the display area,
press the OK button to
confirm.
Used to start/stop the Clean
function.
Turns indoor unit’s LED display
and air conditioner buzzer on and
off (modeldependent), which
create a comfortable and quiet
environment.
To Next Page
Loading...
Need help?
General
