EasyManuals Logo
Home>Huawei>Wireless Access Point>AP5130DN

Huawei AP5130DN User Manual

Huawei AP5130DN
122 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #14 background imageLoading...
Page #14 background image
NOTE
When the WDS/mesh function is enabled on an AP, the blinking frequency of its Wireless LED indicates
the receive signal strength on the WDS/mesh connection by default. After you connect an AP to a WDS/
mesh network, you can run the wifi-light { signal-strength | traffic } command on the AC to make the
Wireless LED blinking frequency indicate receive signal strength or service traffic rate.
l wifi-light signal-strength:
l If the mesh function is enabled on the AP, the blinking frequency of the Wireless LED reflects
the weakest signal strength of all neighboring APs.
l If WDS is enabled on an AP, the blinking frequency of the Wireless LED reflects the strength
of signals received from a WDS AP.
l If the AP works in leaf mode, the blinking frequency of the Wireless LED reflects the strength
of signals received from a middle AP.
l If the AP works in middle mode, the blinking frequency of the Wireless LED reflects the
strength of signals received from a root AP.
l If the AP works in root mode, the blinking frequency of the Wireless LED reflects the weakest
signal strength of middle APs.
l wifi-light traffic: allows the Wireless LED to reflect the service traffic volume on the radio.
The Fat AP does not support WDS/Mesh functions; therefore, the Wireless indicator of the Fat AP does
not indicate the signal strength.
The AP6310SN-GN does not support WDS/mesh functions; therefore, the Wireless indicator of the
AP6310SN-GN does not indicate the signal strength.
1.3 Basic Specifications
Table 1-7 Basic specifications of the AP3010DN-AGN, AP5010SN-GN, AP5010DN-AGN,
AP6010DN-AGN, and AP6010SN-GN
Item Description
Technical
specifications
Dimensions (H x W x
D)
50 mm x 180 mm x 180 mm
Weight 0.4 kg
System memory
l 256 MB DDR2
l 32 MB flash memory
Power specifications Power input
l DC 12 V ± 10%
l PoE power supply: -48 V DC (in
compliance with IEEE 802.3af/at)
NOTE
The AP6010DN-AGN and AP6010SN-GN cannot
use the PoE power supply and DC power supply
simultaneously.
Huawei AP3x10xN&5x10xN&5x30xN&6x10xN&7x10xN
Hardware Installation and Maintenance Guide 1 Indoor AP Overview
Issue 11 (2015-05-18) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Huawei AP5130DN and is the answer not in the manual?

Huawei AP5130DN Specifications

General IconGeneral
BrandHuawei
ModelAP5130DN
CategoryWireless Access Point
LanguageEnglish

Related product manuals