2 x Hose clamp
1 x Indoor fixed-length
Ethernet cable
1 x Indoor-oriented
mounting bracket
1 x N5368X
1 x Outdoor-oriented mounting
bracket (including bolts)
1 x Waterproof
PG connector 1 x Quick Start
M6 hex key
Screwdriver
Adjustable
wrench
Ethernet cable
Rubber
mallet
Hammer
drill
Tools
Before installing the CPE, verify that you have all the items listed in the packing list. If any of the
items is missing or damaged, contact your device provider.
Hardware Introduction
2
You need to prepare the following tools and auxiliary materials:
WiFi
5G
4G
Nano SIMRST LAN WiFi Power/LAN
1
5G Outdoor CPE N5368X
Quick Start
Part Number: 31071318
Version: Draft C
Running Status/Factory Reset Indication
The WiFi indicator, 5G indicator, and 4G indicators are on and off simultaneously.
Color
DescriptionStatus
Steady on
WiFi 5G 4G
Green Green Green
· The device is powered on and starting up.
· The device is running properly. The hardware is
normal, and there is no software alarm.
Blinking thrice (on for
0.5s and off for 0.5s)
Green Green Green
The device is about to restore the factory settings and
restart.
Blinking at 0.5 Hz (on
for 1s and off for 1s)
Yellow Yellow Yellow
The hardware component is normal and the network
searching state starts.
An exception in hardware component is detected.
OffGray Gray Gray
Steady onRed Red Red
The power is off or software configuration is disabled.
If the Wi-Fi hardware switch is turned off, the WiFi
indicator is off.
Upgrade Status Indication
Color
DescriptionStatus
Steady on
5G 4G
Green Green
Blinking(on for 0.2s
and off for 0.2s)
Green Green
The device is restarted for an upgrade to load the new
version. The process is expected to take about 5 minutes.
Blinking (on for 1s
and off for 1s)
Green Green
When the upgrade is successful, the indicator blinks green
slowly thrice, and then the device starts up and enters the
network searching state.
The upgrade fails.Steady onRed Red
· Before an upgrade (normal version verification and
decompression; upgrade in progress)
· After an upgrade (version verification)
LAN Port Status Indication
Color
DescriptionStatus
5G
4G
Blinking at 2 Hz
(on for 0.25s and off for 0.25s)
Red Red The LAN port is not connected.
Color
DescriptionStatus
5G 4G
Blinking at 0.5 Hz
(on for 1s and off for 1s)
Red Red The SIM card is not properly installed or is faulty.
SIM Card Slot Status Indication
To Next Page
Need help?
General
