Device Overview
1
DC chassis
AC chassis
DC and AC Chassis are installed in the same way. For installation
details, see the corresponding installation guide.
Figures in the document are for reference only and may be dierent
from actual devices.
The type and quantity of items in an installation accessory package
vary according to the device model. Check the delivered items
against the actual packing list.
NOTE
DC and AC power modules can be installed in any of the power module
slots on the ATN 910C-K/M and ATN 910D-A.
NOTE
Packing list
Insulation tape
Serial cable
Label cable tie
Fiber binding tape
Panel screw (M6x12)Floating nut (M6)
Signal cable label
Cable tie (300 x 3.6 mm)
Power cable label
Cable management frame
Corrugated pipe ESD wrist strap
To Next Page
Loading...
Need help?
General
