Humminbird ICE HELIX CHIRP Series User Manual

1
ICE HELIX® CHIRP SERIES Quick Start Guide
Power On/Off
1 Power On: Press the POWER key.
2 Select the Start-Up Mode: Press the MENU key on
startup. Select Normal, and press the RIGHT Cursor key.
3 Quick Setup: Use the Cursor Control key to select
settings. Press the EXIT key to close the menu.
Power Off: Press and hold the POWER key.
Select Settings for Ice Fishing
1 Display a Sonar View: Press the VIEW key until a Sonar view is displayed.
2 Open the X-Press™ Menu: Press the MENU key once.
CHIRP IR (Interference Rejection) (CHIRP models only) - If you are fishing near
other ICE flashers or transducers, use CHIRP IR to reduce interference or noise on
the sonar display.
Cone Angle (CHIRP models only) - Select 15º for a narrowly focused down beam.
Select 21º for a wide down beam and larger coverage area. Select 15º-21º to use
the full frequency range for your transducer. CHIRP IR must be off to set the Cone
Angle.
Lower Range - Use the default Auto depth range setting included with your control
head, or manually set the depth range.
A
B
C
532586-1_B
Power On/Off
Open the X-Press Menu
Select a Menu
Select a Setting
A
B
C
ICE_HELIX_QSG_532586-1EN_B.qxp_Layout 6 7/13/18 5:22 PM Page 1

Humminbird ICE HELIX CHIRP Series Specifications

General

Brand	Humminbird
Model	ICE HELIX CHIRP Series
Category	Sonar
Language	English