5
6
S
l
i
d
e
c
a
n
o
p
y
o
v
e
r
d
o
w
n
r
o
d
a
n
d
w
i
r
e
s
.
Place the downrod ball into
the slot in the ceiling bracket.
To prevent damage to fan,
ALWAYS lift holding either the
fan housing or the downrod.
Ceiling Bracket Downrod Hanging Fan Wiring Canopy Blades Light ControlGlass
Follow below if you are using the downrod that came pre-assembled in your box. Need to
install a longer or shorter downrod? Check out the guide at the end of this manual.
1
STEP
Slide the adapter cover onto
the downrod until it rests
against the hanger ball.
K
E
E
P
!
2
STEP
Remove the pre-installed
setscrew so that the
downrod can be inserted.
3
STEP
Pass all wires to one side of horizontal bar
in downrod assembly. Hand tighten the
downrod (at least 4–5 full turns) until it
stops. Trim the wires coming from the fan
so that 8-inches remain coming from the
top of the downrod.
Hunter Pro Tip:
Hunter Pro Tip:
The ground wire attached to the
downrod is approximately 8 inches.
The adapter cover is not used for
low-prole mounting.
Tighten the setscrew
with pliers. DO NOT
HAND TIGHTEN.
4
STEP
FAN FALL HAZARD
To prevent SERIOUS INJURY or DEATH:
• ALWAYS tighten setscrew with pliers.
• DO NOT hand tighten setscrew.
• CHECK the setscrew is tight using pliers
each time you change fan direction.
5
STEP
Lower the adapter cover until it rests ush
against the motor housing.
To Next Page
Loading...
Need help?
General
