2
CONNECTING THE BATTERY..........
The SVC uses a standard 9-volt alkaline battery (not
included) to operate the valve and program the controller.
The life of the battery is determined by the number of valve
actuations, however, under normal conditions the battery
should provide at least one full year of service.
NOTE: The SVC has non-volatile memory
which allows for the battery to be removed
without losing any program information.
To install the battery:
1. Unscrew the rear half of the SVC body to gain access to
the battery compartment.
2. Snap the battery into the battery holder.
NOTE: The battery holder is designed so that
the battery can only be inserted one way.
3. Make sure no water is inside the battery compartment.
Screw the SVC body halves together to seal the compart-
ment.
LIT-354 SVC Owners Manual.RevA 2 3/21/02, 1:53:32 PM
To Next Page
Loading...
Need help?
General
