Hunter X2 User Manual

Setting Station Run Times
1. Turn the dial to the RUN TIMES position.
2. Use the PRG button to select program
(A, B, or C).
3. Use the + and - buttons to change the station
run time on the display. You can set station run
times from 1 minute to 6 hours.
4. Press the ► button to advance to the next
station.
5. Repeat for each station.
Setting Water Days
1. Turn the dial to the WATER DAYS position.
2. The display will show the last program se-
lected (A, B, or C). Switch to another program
by pressing the PRG button.
3. The pointer at the bottom of the screen shows
the currently selected day of the week. Press +
or – to select days for watering or no water .
Selecting Odd or Even Days to Water
1. Press ► past all days of week to ODD or EVEN.
2. Press + to select or – to cancel ODD or EVEN.
Selecting Interval Watering
1. Press ► past ODD and EVEN to INT.
2. Press + or – to set interval days.
3. Press + or – to set number of days to next
watering.
Pump/Master Valve (P/MV)
Press ► to select stations. Press + or – to set P/
MV output ON or OFF for station. (P/MV is
normally on for all stations.)
Seasonal Adjust
Changes all run times by a percentage for local
conditions.
Press + or – to change from 10% to 200% of
original run times.
Manual Station
1. Turn dial to Manual position.
2. Press ► to select station. Use + or – to set
manual run time.
3. Turn dial to Run position to begin immediately.
Manual Program
1. Turn dial to RUN position.
2. Press and hold ► button for three seconds.
3. Press PRG to select program.
4. Release button for two seconds. Program
will begin.
5. Press ► to advance to another station within
the Program.
One-Touch Manual Start and Advance
1. Hold down the right button for two seconds.
2. Press the PRG button to select program.
3. Press the le or right button to select a station.
4. Press the + or – button to change the run time.
5. Aer a two-second pause, the program will
begin. At any time during manual cycle, use the
le or right buttons to navigate from station to
station manually.
Test Program
Runs all stations for a test run time.
1. Press and hold PRG for three seconds.
2. Station 1 appears. Press + or - to enter run time.
3. Wait two seconds, each station will run for test
run time.
System O
Turn dial to System OFF position. No watering will
occur in this dial position.
Programmable Rain O
1. Turn dial to System OFF position, wait for OFF to
stop blinking.
2. Press + or – to set the number of days to
remain o.
3. Turn dial back to RUN position. Display will
show days o remaining, and watering will
resume when O days reach 0. To cancel Rain
O, turn dial to OFF, wait until OFF stops blink-
ing, then turn dial back to Run.
Sensor Bypass
Overrides sensor shutdown to allow watering.
1. Move sensor BYPASS switch to BYPASS
position.
2. Return switch to ACTIVE to allow sensor
shutdown.
SCHEDULING TIPS
A program is a watering schedule that includes a
start time(s), run time(s), and water way(s).
A Start Time is the time of day the Stations in the
Program start watering.
A Run Time is the watering length per Station
(zone).
One Start Time is needed to run the entire
program.
|For more information visit Thelandscapestore.com.au | (02) 9161 3939 |

Hunter X2 Specifications

General

Brand	Hunter
Model	X2
Category	Controller
Language	English