The workbench has pre-threaded holes on the back
and side of the unit for the installation of optional
pegboard back wall (Model #D6T09001). Refer to
huskytools.com or homedepot.com for more details.
□
7 Please contact 1-888-HD-HUSKY
HUSKYTOOLS.COM
for further assistance.
Optional Attachment
Operation
1
Removing the drawers
2
Re-inserting the drawers
Fully extend the empty drawer.
□
□
elihw revel esaeler eno eht pu hsuP pulling
down on the other release lever.
□ Pull the drawer outward until it is released from the
drawer slide.
Extend the drawer slides.
□
□
Insert the brackets on each side of the drawer into
the slots in the slides, being careful that they are
properly positioned.
□ Once properly inserted, completely close the drawer
to set the slides
in their proper positions.
FIG. 7
NOTE:
Caster hubcap may be different than
shown in diagram.
To Next Page
Loading...
Need help?
General
