Husqvarna 120i User Manual

32 – English
TECHNICAL DATA
Recommended cutting equipment for USA
Following is a list of recommended cutting equipment for Husqvarna cordless chain saw model 120i. This chain saw
model equipped with either of the listed guide bar and saw chain combination(s), fulfills the requirements according to
UL 60745-2-13.
Chain saw model Husqvarna 120i met the kickback performance requirements of ANSI B175.1-2012 when tested with
the combinations of bars and saw chains listed below. The saw chain Husqvarna H38 is also classified as a low kickback
saw chain since it met the requirements for low kickback saw chain outlined in ANSI B175.1-2012. We recommend to
use only the listed combinations of bars and chains for chain saw model Husqvarna 120i. Other chain saw models may
not meet the kickback requirements when equipped with the listed guide bar and saw chain combinations.
Recommended cutting equipment for Canada
Following is a list of recommended cutting equipment for the Husqvarna cordless chain saw model 120i. The listed
combination(s) of powerhead, guide bar and saw chain meet all requirements outlined in Canadian Standards
Assosiation Z62.1-11 (Chain Saws) and Z62.3-11 (Chain Saw Kickback).
Furthermore the saw chain Husqvarna H38 is evaluated and listed as a Type C Low Kickback Saw chain according to
the provisions in Z62.3-11.
Kickback information
The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the
corresponding maximum nose radius of a solid bar.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list.
For guide bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of
sprocket teeth may be considered to have equivalent kickback energy.
The following cutting attachments are approved for the model Husqvarna 120i.
Guide bar Saw chain
Length, inch Pitch, inch Gauge, inch
Max. nose
radius
Type Drive link count
14 3/8 0.050 7T Husqvarna H37 52

Husqvarna 120i Specifications

General

Battery Type	Li-Ion
Battery Voltage	36 V
Chain Speed	11.5 m/s
Weight (excl. battery and cutting equipment)	2.95 kg
Weight (without battery and cutting equipment)	2.95 kg
Sound Pressure Level at Operator's Ear	83 dB(A)
Oil Tank Volume	0.2 l
Vibration Level (Rear Handle)	3.5 m/s²
Chain Gauge	0.043"
Chain Pitch	3/8"