Husqvarna 340iBT User Manual

To put the product in transportation
mode
1. Turn the blower tube until it points up.
2. Connect the transport clip.
Operation
Introduction
WARNING: Read and understand the safety
chapter before you use the product.
To connect the battery to the product
WARNING: Only use Husqvarna original
batteries in the product.
1. Charge the battery fully.
2. Push the battery into the battery holder of the
backpack. The battery locks into position when you
hear a click.
CAUTION: If the battery does not move
easily into the battery holder, the battery
is not installed correctly. This can cause
damage to the product.
To start the product
1. Push and hold the start/stop button until the green
LED light on the user interface comes on.
2. Use the power trigger to control the speed.
To stop the product
1. Release the power trigger.
2. Push and hold the start/stop button until the green
LED light goes off.
3. Push the release buttons on the battery and remove
the battery from the product.
1166 - 002 - 29.10.2019 15

Husqvarna 340iBT Specifications

General

Brand	Husqvarna
Model	340iBT
Category	Blower
Language	English