EasyManua.ls Logo

Husqvarna 525LS Mark II User Manual

Husqvarna 525LS Mark II
76 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #22 background imageLoading...
Page #22 background image
Warranty
CALIFORNIA, U.S FEDERAL, AND
CANADA EXHAUST AND
EVAPORATIVE EMISSIONS
CONTROL WARRANTY STATEMENT
YOUR WARRANTY RIGHTS AND OBLIGATIONS
The California Air Resources Board (CARB), U.S.
Environmental Protection Agency (EPA), Environment
and Climate Change Canada and Husqvarna Forest &
Garden are pleased to explain the exhaust and
evaporative emissions ("emissions") control system
warranty on your 2020-2021* small off-road engine. In
California, new equipment that use small off-road
engines must be designed, built, and equipped to meet
State's stringent anti-smog standards. Husqvarna Forest
& Garden must warrant the emissions control system on
your small off-road engine for the periods of time listed
below provided there has been no abuse, neglect or
improper maintenance of your small off-road engine or
equipment leading to the failure of the emissions control
system. Your emissions control system may include
parts such as the carburetor or fuel injection system, the
ignition system, catalytic convertor, fuel tanks, fuel lines
(for liquid fuel and fuel vapors), fuel caps, valves,
canisters, filters, clamps and other associated
components. Also included may be hoses, belts,
connectors, and other emission-related assemblies.
Where a warrantable condition exists, Husqvarna Forest
& Garden will repair your small off-road engine at no
cost to you including diagnosis, parts and labor.
MANUFACTURER′S WARRANTY COVERAGE
The exhaust and evaporative emissions control system
on your small off-road engine is warranted for two years.
If any emissions-related part on your small off-road
engine is defective, the part will be repaired or replaced
by Husqvarna Forest & Garden.
OWNER′S WARRANTY RESPONSIBILITIES
As the small off-road engine owner, you are
responsible for performance of the required
maintenance listed in your owner’s manual.
Husqvarna Forest & Garden recommends that you
retain all receipts covering maintenance on your
small off-road engine, but Husqvarna Forest &
Garden cannot deny warranty coverage solely for
the lack of receipts or for your failure to ensure the
performance of all scheduled maintenance.
As the small off-road engine owner, you should
however be aware that Husqvarna Forest & Garden
may deny you warranty coverage if your small off-
road engine or a part has failed due to abuse,
neglect, or improper maintenance or unapproved
modifications.
You are responsible for presenting your small off-
road engine to a Husqvarna Forest & Garden
authorized servicing dealer as soon as the problem
exists. The warranty repairs shall be completed in a
reasonable amount of time, not to exceed 30 days. If
you have any questions regarding your warranty
rights and responsibilities, you should contact
Husqvarna Forest & Garden in USA at
1-800-487-5951, in CANADA at 1-800-805-5523 or
send e-mail correspondence to
emissions@husqvarnagroup.com or warranty@hpp-
emissions.com.
WARRANTY COMMENCEMENT DATE
The warranty period begins on the date the engine or
equipment is delivered to an ultimate purchaser.
LENGTH OF COVERAGE
Husqvarna Forest & Garden warrants to the ultimate
purchaser and each subsequent owner that the engine
or equipment is designed, built, and equipped so as to
conform with all applicable regulations adopted by
CARB and EPA, and is free from defects in materials
and workmanship that causes the failure of a warranted
part for a period of two years.
WHAT IS COVERED
REPAIR OR REPLACEMENT OF PARTS: Repair or
replacement of any defective warranted part will be
performed at no charge to you at a brand authorized
servicing dealer. Except for repairs and replacement
under this Emission Control Warranty, you may choose
a repair shop or other person to maintain, replace or
repair emission control devices and systems. However,
Husqvarna Forest & Garden recommends that all
maintenance, replacement and repairs of emission
control devices and systems be performed by a brand
authorized servicing dealer.
IMPORTANT:This product is compliant with U.S. EPA
Phase 3 regulations for exhaust and evaporative
emissions. To ensure EPA Phase 3, California Air
Resources Board and Environment and Climate Change
Canada regulation, we recommend using only genuine
product branded replacement parts. Use of non-
compliant replacement parts is a violation of federal and
state laws.
WARRANTY PERIOD: Any warranted part which is not
scheduled for replacement as required maintenance, or
which is scheduled only for regular inspection to the
effect of "repair or replace as necessary" is warranted
for 2 years (or time defined in the product warranty
statement, whichever is longer) from the date of
purchase by the initial consumer purchaser. Any
warranted part which is scheduled for replacement as
required maintenance is warranted for the period of the
time up to the first scheduled replacement for that part.
Any part repaired or replaced under the warranty must
be warranted for the remaining warranty period.
22
1560 - 002 - 22.06.2021

Questions and Answers:

Husqvarna 525LS Mark II Specifications

General IconGeneral
BrandHusqvarna
Model525LS Mark II
CategoryChainsaw
LanguageEnglish

Summary

Introduction and Product Overview

Product Overview

Visual guide to the product's components with numbered parts.

Product Description

Details the product's nature as a combustion engine grass trimmer.

Intended Use

Specifies the product's primary function is grass cutting and clearing.

Safety Information

Symbols and Warnings

Explains warning symbols and safety decals found on the product.

Safety Definitions

Defines key terms like WARNING and CAUTION for user understanding.

General Safety Instructions

Provides crucial general safety precautions for operating the product.

Operation Safety Instructions

Outlines specific safety measures to follow during product use.

Personal Protective Equipment (PPE)

Details essential PPE required for safe operation and injury prevention.

Product Safety Devices and Checks

Covers safety features and necessary checks for proper product functioning.

Muffler and Fuel Safety

Muffler Maintenance and Safety

Details inspection and maintenance of the muffler for noise and safety.

Fuel Safety Guidelines

Provides critical safety guidelines for handling and using fuel.

Assembly Procedures

Safety Instructions for Maintenance

Emphasizes safety precautions before performing any maintenance tasks.

Loop Handle Assembly

Detailed steps for attaching and adjusting the loop handle.

Cutting Attachment Guard and Trimmer Head Assembly

Instructions for fitting the cutting attachment guard and trimmer head.

Product Operation

Pre-Operation Checks

Essential checks to perform before starting the product operation.

Connectivity Features

Information on the product's connectivity capabilities and device installation.

Installing Connectivity Device

Step-by-step guide for installing the Husqvarna connectivity device.

Fueling Guidelines

Details on fuel types, mixing, and safety precautions for the two-stroke engine.

Mixing Fuel

Instructions and ratios for mixing gasoline and two-stroke oil.

Filling the Fuel Tank

Procedure for safely filling the product's fuel tank.

Preparing for Cold Start

Steps to prepare a cold engine for starting using the air purge bulb.

Starting the Product

Step-by-step guide for safely starting the product's engine.

Stopping the Product

Instructions for safely stopping the product's engine.

Surface Safety Precautions

Warnings about hot surfaces and electrical shock risks when operating.

Grass Trimming Techniques

Trimming the Grass

Specific steps and techniques for trimming grass.

Cutting the Grass

Guidance on how to cut grass correctly with the trimmer line.

Sweeping the Grass

Technique for using airflow to clear cut grass from an area.

Product Maintenance

Maintenance Schedule

Schedule detailing daily, weekly, and monthly maintenance tasks.

Adjusting Idle Speed

Procedure for adjusting the engine's idle speed.

Muffler Maintenance

Steps for maintaining the muffler, including spark arrestor screen.

Cooling System Maintenance

Instructions for cleaning and maintaining the product's cooling system.

Air Filter Maintenance

Steps for cleaning and replacing the air filter to ensure proper engine function.

Spark Plug Examination and Maintenance

Guidance on inspecting, cleaning, and replacing the spark plug.

Bevel Gear Inspection

Instructions for checking and greasing the bevel gear.

Troubleshooting Guide

Engine Does Not Start

Common causes and procedures for addressing engine starting issues.

Engine Starts But Stops Again

Troubleshooting steps for when the engine starts and then stops.

Transportation and Storage

Technical Specifications

Provides key technical data for the 525LS Mark II and 525LST Mark II models.

Approved Accessories

Warranty Information

Emissions Control Warranty Statement

Details the warranty coverage for exhaust and evaporative emissions control systems.

Warranty Rights and Obligations

Explains the owner's responsibilities and rights regarding the warranty.

Manufacturer's Warranty Coverage

Outlines the scope of the manufacturer's warranty for emissions control parts.

Owner's Warranty Responsibilities

Details the owner's duties for maintaining warranty validity.

What is Covered by Warranty

Specifies which parts and conditions are covered under the warranty.

What is Not Covered by Warranty

Lists conditions and parts excluded from warranty coverage.

How to File a Warranty Claim

Instructions on how to contact Husqvarna for warranty service and claims.

Where to Get Warranty Service

Information on finding authorized servicing dealers for warranty repairs.

Emission-Related Parts Maintenance

Guidelines for maintenance and repair of emission control components.

Maintenance Statement

Clarifies owner's responsibility for performing required maintenance.

Related product manuals