Husqvarna 7021P User Manual

5
ASSEMBLY
TO ASSEMBLE GRASS CATCHER
(See Fig. 2)
1. Put grass catcher frame into grass bag with rigid part
of bag on the bottom. Make sure the frame handle is
outside of the bag top.
2. Slip vinyl bindings over frame.
NOTE: If vinyl bindings are too stiff, hold them in warm water
for a few minutes. If bag gets wet, let it dry before using.
INSTALL STARTER ROPE (See Fig. 3)
1. Loosen T-knob.
2. Hold control bar against upper handle.
3. Slowly pull engine starter rope out until rope will slip
into loop of rope guide.
4. Tighten T-knob.
FIG. 2
FRAME
HANDLE
VINYL
BINDINGS
FRAME
OPENING
TO INSTALL ATTACHMENTS
Your lawn mower was shipped ready to be used as a
mulcher. To convert mower to bagging or discharging,
see “TO CON VERT MOWER” in the Operation section of
this man u al.
FIG. 3
UPPER
HANDLE
CONTROL BAR
ENGINE
STARTER
ROPE
ROPE GUIDE T-KNOB

Husqvarna 7021P Specifications

General

Cutting Width	21 inches
Drive System	Push
Grass Collector	Yes
Mulching Capability	Yes
Engine Displacement	160 cc
Bagging Capability	Yes
Side Discharge	Yes
Starter Type	Recoil
Engine Type	4-stroke
Wheel Size	8-inch front, 12-inch rear
Engine	Briggs & Stratton