EasyManuals Logo
Home>Hypertherm>Welding System>MAX200

Hypertherm MAX200 Field Service Bulletin

Hypertherm MAX200
10 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
Page 3
Field Service Bulletin 801270
MAX200 UNDERWATER TORCH SUPPLEMENT
Setup
See
Section 3, Setup
, in the MAX200 instruction manual 800870 to make all connections
to the MAX200 system.
To provide the diver with a margin of safety, underwater cutting also requires connecting
the remote switch 028328 in series with the torch start switch.
Diver Safety Switch Connections
1. Looking at the power supply from the front, remove its right side cover.
2. Remove the power supply rear cover.
3. Route the remote switch cable through the feed-through at the rear of the power
supply. See Figure 1.
Feed Through
Figure 1 Remote Switch Feed-Through Location

Other manuals for Hypertherm MAX200

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hypertherm MAX200 and is the answer not in the manual?

Hypertherm MAX200 Specifications

General IconGeneral
BrandHypertherm
ModelMAX200
CategoryWelding System
LanguageEnglish

Related product manuals