Hypertherm MAX40 User Manual

Page 6
Remote Switch Installation Manual
INSTALLATION
To install the remote switch on the MAX40 or HT40C plasma system, perform the following
procedure and see Figure 1. See Figure 4 for additional information.
1. Remove the rear cover of the power supply.
2. Feed the remote switch cable through the torch lead hole at the rear of the power
supply. Locate terminal strips 1TB and 2TB on the right side of the center panel.
Connect the remote switch wire pairs to 2TB and 1TB as follows:
Remote Switch Installation - MAX40 & HT40C
riaPeriW BT2 emaNlangiS
)43(kcalB
)33(deR
43
33
tratSamsalP
tratSamsalP
riaPeriW BT1 emaNlangiS
)83(kcalB
)73(etihW
1
2
toHCAV42
tueNCAV42
3. Replace and secure the rear cover.
Figure 1 Remote Switch Installation - MAX40 & HT40C
2TB
1TB
33 33
34 34
1 1 2 2 2 3 4
4
38 37
BLK
RED
BLK
WHT
2 2 3 4 4
1

Hypertherm MAX40 Specifications

General

Brand	Hypertherm
Model	MAX40
Category	Remote Control
Language	English