Hypertherm MAX40 User Manual

Page 8
Remote Switch Installation Manual
INSTALLATION
Figure 3 Remote Switch Installation - MAX200
To install the remote switch on the MAX200 plasma system, perform the following procedure
and see Figure 3. See Figure 4 for additional information.
1. Remove the right side cover of the power supply.
2. Feed the remote switch cable through the feed-through at the rear of the power
supply. Locate terminal strips TB3 and TB4 on the inside rear panel, right side.
Connect the remote switch wire pairs to TB3 and TB4 as follows:
Remote Switch Installation - MAX200
3. Replace and secure the right side cover.
riaPeriW 3BT emaNlangiS
)43(kcalB
)33(deR
28
38
tratSamsalP
tratSamsalP
riaPeriW 4BT emaNlangiS
)83(kcalB
)73(etihW
67
77
toHCAV42
tueNCAV42
TB4
34 35
BLK
38
88 89
34 35 76 77 88 89
37
WHT
TB3
61 60 78 79 80 81 82 83 84 85 86 87
61 60 78 79 80
81
84 85 86 87
34 33
BLK
RED

Hypertherm MAX40 Specifications

General

Brand	Hypertherm
Model	MAX40
Category	Remote Control
Language	English