Quick Reference Guide
Powermax65/85/105SYNC™
WARNING!
READ THE SAFETY INFORMATION
Before operating or maintaining any Hypertherm equipment, read the Safety and
Compliance Manual and the Operator Manual for important safety information.
The system comes with the following product documentation:
• Quick Setup Guide (810520MU)
• Cut Charts Guide (810500MU)
• USB memory stick:
• Operator Manual (810470)
• Safety and Compliance Manual (80669C)
• Mechanized Cutting Guide (810480)
• Parts Guide (810490)
Much of this Quick Reference Guide is specific to hand cutting. For information
on mechanized cutting, refer to the Mechanized Cutting Guide.
Select the cartridge
This system uses a single-piece cartridge instead of a set of consumables that contains
4or 5 separate parts.
Drag cutting
Standard hand cutting cartridges: drag cut for the widest range of hand cutting and
piercing applications.
FineCut
FineCut
®
cartridges: get a narrower kerf on thin mild steel and stainless steel up to 3mm
(10gauge).
Max Removal
gouging
Maximum Removal gouging cartridges: for aggressive metal removal, deep gouge
contours, and extreme metal washing.
Max Control
gouging
Maximum Control gouging cartridges: for more precise metal removal, shallower gouge
contours, and light metal washing.
Mechanized
cutting
Standard mechanized cutting cartridges: for use on machine torches for the widest
range of mechanized cutting applications.
FlushCut
FlushCut
®
cartridges: remove lugs, bolts, pad eyes, and other attachments without
piercing or damaging the workpiece below.
To Next Page
Need help?
General
