OPERATION
WARNING: Before connecting to the mains supply, always
check the switch is in the off position!
Cable Tidy/Restraint
We recommend using your mower as outlined in this section
in order to achieve optimum results and to reduce the risk of
cutting the mains cable.
Place the bulk of the mains cable on the lawn, close to the
starting point.
Feed the cable through the cable restraint.
Plug the machine into the electric supply, ensuring it meets the
recommended requirements.
Electrical power should be supplied via a residual current
device (RCD) with a tripping current of not more than 30 mA.
Switch the mower on as described above.
Start the motor
Press the safety button of the switch assembly and then pull
the OPC Lever against the bar.