4. STOPPING PROCEDURE
4.1. Before stopping the machine allow the engine to cool down for a few minutes.
4.2. You MUST allow the blades to come to a full stop before carrying out any maintenance on the
machine.
To STOP the machine release both the Operator Presence Control (OPC) and drive control
levers by allowing them to move away from the main handle. You must turn the start key to
the OFF position to avoid battery discharging.
TO MOVE MACHINE FORWARDS you must hold both the Operator Presence Control and
Drive control levers. They must both be pulled towards main handle.
To Next Page
Loading...
Need help?
General
