FEATURES OF YOUR HYUNDAI
1- 53
B710A01L-AAT
VENTILATION
To operate the ventilation system:
o Set the air intake control at the fresh air ( )
position.
o To direct all intake air to the dashboard vents,
set the airflow control to the face ( )
position.
o Adjust the fan speed control to the desired
speed.
B710B01A-AAT
Center Ventilator
The center ventilators are located in the middle
of the dashboard.
To change the direction of the airflow, turn the
control knob on the middle of the ventilator as
desired.
B710B01L
B710C01L
The side ventilators are located on each side of
the dash board. The side vent knobs control the
amount of outside air entering the vehicle through
the side vents. These vents can also be
closed,so no air enters through the side vents.
To change the direction of the air flow, turn the
control knobs as desired.
B710C01Y-AAT
Side Ventilator
B720A02F-AAT
DEFROSTING/DEFOGGING
Use the heating/ventilation system to defrost or
defog the windshield:
To remove the interior fog on the windshield:
o Set the air flow control to the defrost ( )
position. (The A/C will be on automatically
and it will be changed to "Fresh" mode)
o Set the temperature control at the desired
position.
o Set the fan speed control between "1" and
"4" position.
To remove the frost or exterior fog on the
windshield:
o Set the air flow control to the defrost ( )
position. (The A/C will be on automatically
and it will be changed to "Fresh" mode)
o Set the temperature control to the warm.
o Set the fan speed control to position "3" or
"4".
B720A01L
To Next Page
Loading...
Need help?
General
