EasyManuals Logo
Home>IBM>Server>Power E1050

IBM Power E1050 User Manual

IBM Power E1050
48 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #24 background imageLoading...
Page #24 background image
Figure 3. Installing or replacing an NVMe U.2 drive
4. Repeat this procedure for each NVMe U.2 drive.
Replacing an adapter in the 9043-MRX system
To replace an adapter in the system, complete the steps in this procedure.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
2. Ensure that the target slot is empty.
3. Place the adapter, component-side up, on a flat, antistatic surface.
Attention:
A pin on the tailstock of the adapter resembles a removable screw. Do not remove
this pin. It is required for correct alignment and seating.
4. Install or replace an adapter into the cassette:
a) Open the tailstock clamp by rotating the clamp to the right.
b) Open the cassette by pressing and sliding the release bar on the bottom of the cassette to the rear
of the cassette.
c) Insert the adapter into the cassette.
10
Power Systems: Installing the IBM Power E1050 (9043-MRX)

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the IBM Power E1050 and is the answer not in the manual?

IBM Power E1050 Specifications

General IconGeneral
BrandIBM
ModelPower E1050
CategoryServer
LanguageEnglish

Related product manuals