IBM Power System S822 User Manual

Installing the cable-management arm
The cable-management arm is used to efficiently route cables so that you have proper access to the rear
of the system. Use the procedure to install the cable-management arm.
To install the cable-management arm, complete the following steps:
1. Ensure that you have the following parts.
A Support arm
B Cable-management stop bracket
C Mounting bracket
D Cable-management arm
E Extension bracket
2. The cable-management arm can be installed on either side of the server. For this procedure, it is
illustrated that you are installing it on the right side, while you are facing the server from the rear.
2
P8EG1501-0
1
Figure 8. Lift the release latches and push the server into the rack
Figure 9. Relative positions of the cable-management arm parts before assembly
Installing the IBM Power System S822 (8284-22A) 7

IBM Power System S822 Specifications

General

Brand	IBM
Model	Power System S822
Category	Desktop
Language	English