Example symbol Symbol meaning
A potential hazard of pinching the hand or other body parts between parts.
A hazardous condition due to moving parts nearby.
A hazardous condition due to the use of a laser in the product. Laser symbols
are always accompanied by the classification of the laser as defined by the U. S.
Department of Health and Human Services (for example, Class I, Class II, and so
forth).
Read and comply with the following caution notices before installing or servicing this device.
CAUTION: Energy hazard present. Shorting may result in system outage
and possible physical injury. Remove all metallic jewelry before servicing.
(C001)
>55kg (121.2 lb)
CAUTION: The weight of this part or unit is more than 55 kg (121.2 lb).
It takes specially trained persons, a lifting device, or both to safely lift this
part or unit. (C011)
CAUTION: The system contains circuit cards, assemblies, or both
that may contain lead solder. To avoid the release of lead (Pb) into the
environment, do not burn. Discard the circuit card as instructed by local
regulations. (C014)
CAUTION: This product is equipped with a 3-wire (two conductors
and ground) power cable and plug. Use this power cable with a properly
grounded electrical outlet to avoid electrical shock. (C018)
CAUTION: This product might contain one or more of the following
devices: CD-ROM drive, DVD-ROM drive, DVD-RAM drive, or laser module,
which are Class 1 laser products. Note the following information:
• Do not remove the covers. Removing the covers of the laser product could
result in exposure to hazardous laser radiation. There are no serviceable
parts inside the device.
• Use of the controls or adjustments or performance of procedures other
than those specified herein might result in hazardous radiation exposure.
(C026)
xviiiIBM Storage Networking SAN192C-6, SAN384C-6 and SAN768C-6: SAN192C-6, SAN384C-6 and
SAN768C-6 Installation, Service, and User Guide
To Next Page
Loading...
Need help?
General