Select this choice to view or change the memory settings.
– Devices and I/O Ports
Select this choice to view or change assignments for devices and input/output
(I/O) ports. You can configure the serial ports; configure remote console
redirection; enable or disable integrated Ethernet controllers. If you disable a
device, it cannot be configured, and the operating system will not be able to
detect it (this is equivalent to disconnecting the device).
– Power
Select this choice to view or change power capping to control consumption,
processors, and performance states.
– Legacy Support
Select this choice to view or set legacy support.
- Force Legacy Video on Boot
Select this choice to force INT video support, if the operating system does
not support UEFI video output standards.
- Rehook INT 19h
Select this choice to enable or disable devices from taking control of the
boot process. The default is Disable.
- Legacy Thunk Support
Select this choice to enable or disable UEFI to interact with PCI mass
storage devices that are non-UEFI compliant.
– integrated management module II
Select this choice to view or change the settings for the integrated
management module II.
- POST Watchdog Timer
Select this choice to view or enable the POST watchdog timer.
- POST Watchdog Timer Value
Select this choice to view or set the POST loader watchdog timer value.
- Reboot System on NMI
Enable or disable restarting the system whenever a nonmaskable interrupt
(NMI) occurs. Enable is the default.
- Commands on USB Interface Preference
Select this choice to enable or disable the Ethernet over USB interface on
IMM2.
- Network Configuration
Select this choice to view the system management network interface port,
the IMM2 MAC address, the current IMM2 IP address, and the host name;
define the static IMM2 IP address, subnet mask, and gateway address;
specify whether to use the static IP address or have DHCP assign the
IMM2 IP address; save the network changes; and reset the IMM2.
- Reset IMM2 to Defaults
Select this choice to view or reset IMM2 to the default settings.
- Reset IMM2
Select this choice to reset IMM2.
– Adapters and UEFI Drivers
Select this choice to view information about the UEFI 1.10 and UEFI 2.0
compliant adapters and drivers installed in the server.
– Network
Chapter 3. Configuring the server 55
To Next Page
Loading...
Need help?
General