1100 Palm rest or Palm rest with
fingerprint sensor (for 14.1-in. LCD
models)
For access, remove these FRUs in order:
v “1010 Battery pack for 14.1-in. LCD models” on page 71
v “1040 Hard disk drive” on page 75
v “1060 Keyboard” on page 79
Notes
v In models with the fingerprint sensor, the sensor
has been attached to the palm rest FRU as the
child part. In case of the fingerprint sensor has
any defects and needs to be replaced, you need
to replace the palm rest by following the
procedures in this section. The procedures are
same both for the palm rest without the fingerprint
sensor and for the palm rest with the fingerprint
sensor.
v In models xxU and xxF, this FRU is secured by
using a tamper resistant torx head screw (TR7).
(continued)
Removing and replacing a FRU
88 T40/T40p, T41/T41p, T42/T42p
To Next Page
Loading...
Need help?
General