FLOOR MACHINE OPERATING INSTRUCTIONS
OPERATOR
General Use:
1) Remove any obstructions or other obstacles in the area which is to be cleaned.
2) Make sure the safety installation is right place and tighten the release handle.
Be sure the machine is not plugged into an outlet.
8) Release the compression handle and adjust handle height to a comfortable operating position,
then push back down on the compression handle to lock the handle in operating position.
9)To start the machine, push on the Blue safety button of the top of upper switch housing and
squeeze either of the switch levers.
10) When the machine is in operation, both hands should be placed on the handle (switch
housing).
11)To stop the machine at any time, simply release the switch lever, and the machine will stop
automatically.
Do not use an extension cord in conjunction with the standard power cord.
4) Remove the pad center gripping device by unscrewing the thumbscrews.
5) Place appropriate burnishing pad on pad driver and re-attach the center gripping device.
6) Place machine back into its upright position.
7) Plug power cord into grounded outlet.
STORAGE
1) Unplug machine from power source and wrap cord on handle.
2) Tilt machine back and remove pad driver or brush.
3) Store in upright position in a dry area.
MAINTENANCE
To keep the machine performing well for many years, please follow the following maintenance
procedures.
Always confirm that the machine is unplugged prior to performing any
maintenance or repairs.
1. Unplug machine as soon as you are done using it.
2. Make sure the safety installation is right place and tighten the release handle.
3. Tilt machine back and remove pad driver or brush.
Never store a low speed machine with the pad driver or brush mounted
to the machine.
4. Clean the outside of the machine with a mild cleaner.
5. Check power cord for any damage.If damage is detected, replacepower cord immediately.
6. Lubricate wheels with a water resistant lubricant once a month.
7. Check machine for loose or missing nuts and bolts, and replace as necessary.
8. If the machine is used in a dusty environment, you may remove themotor cover and blow the
motor clean with compressed air. This willensure proper ventilation, and allowthe motor to run
cooler.
ICE iP17 iP20
To Next Page
Loading...
Need help?
General
