EasyManuals Logo
Home>Icom>Transceiver>IC-A16

Icom IC-A16 User Manual

Icom IC-A16
35 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #2 background imageLoading...
Page #2 background image
INTRODUCTION
This service manual describes the latest technical
information for the IC-A16/IC-A16E VHF AIR BAND
TRANSCEIVERS at the time of publication.
MODEL VERSION
VERSION
NUMBER
Bluetooth WX RX
IC-A16 USA-01 #11
IC-A16E
EUR-01 #12
EUR-02 #13
IC-A16 USA-02 #21
IC-A16E
EUR-03 #22
EUR-04 #23
To upgrade quality, any electrical or mechanical parts and
internal circuits are subject to change without notice or
obligation.
SERVICE CAUTION
NEVER connect the transceiver to a DC power supply
that outputs more than the specified voltage. This will
ruin the transceiver.
DO NOT reverse the polarity of the DC power cord
when directly applying power to the transceiver.
DO NOT apply an RF signal of more than 20 dBm
(100 mW) to the antenna connector. This could
damage the transceiver’s front-end.
ORDERING PARTS
Be sure to include the following four points when
ordering replacement parts:
1. 10-digit Icom part number
2. Component name
3. Equipment model name and unit name
4. Quantity required
<ORDER EXAMPLE>
1130017460 AK1542A-L IC-A16 MAIN UNIT 5 pieces
8830004260 3776 ANT NUT IC-A16 CHASSIS 1 piece
Addresses are provided on the inside back cover for
your convenience.
REPAIR NOTES
1. Make sure that the problem is internal before
disassembling the transceiver.
2. DO NOT open the transceiver until the transceiver
is disconnected from its power source.
3. DO NOT short any circuits or electronic parts.
4. DO NOT keep power ON for a long time when the
transceiver is defective.
5. NEVER directly transmit power into any test
equipment such as Standard Signal Generator or
a Sweep Generator, otherwise the RF power may
damage them.
6. ALWAYS connect a 30 dB attenuator between the
transceiver and such test equipment.
7. READ the instructions of the test equipment
thoroughly before connecting it to the transceiver.
8. If the front panel and chassis are separated and
reassembled, waterproof performance will not be
guaranteed unless the specified waterproof check
is performed.
Icom, Icom Inc. and the Icom logo are registered trademarks of Icom Incorporated (Japan) in Japan, the United States, the
United Kingdom, Germany, France, Spain, Russia, Australia, New Zealand, and/or other countries.
IC-A16 IC-A16E

Other manuals for Icom IC-A16

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Icom IC-A16 and is the answer not in the manual?

Icom IC-A16 Specifications

General IconGeneral
BrandIcom
ModelIC-A16
CategoryTransceiver
LanguageEnglish

Related product manuals