Need help?Do you have a question about the Icom IC-A2 and is the answer not in the manual?
General| Brand | Icom |
|---|---|
| Model | IC-A2 |
| Category | Transceiver |
| Language | English |
Describes the IC-A2 as a compact, synthesized, 5 watt PEP, VHF handheld transceiver.
Details the extensive COM and NAV channel coverage with 12.5kHz spacing.
Highlights metal case construction and stainless steel rails for durability.
Explains direct operation from aircraft 12V power and battery charging.
States the transceiver has ten memory channels for storing frequencies.
Details general specifications including semiconductors, memory channels, frequency control, and stability.
Details receiver specifications like frequency range, sensitivity, and selectivity.
Details transmitter specifications like output power, modulation, and emission.
Provides instructions for carefully removing the transceiver and checking for shipping damage.
Explains how to install the NiCd battery pack and notes on battery memory effect.
Details charging methods using wall charger, desk charger, or 12V battery.
Explains how to use an external 13.8V DC regulated power supply or battery.
Provides essential safety precautions for handling and charging NiCd batteries.
Provides instructions for attaching optional hand strap and belt clip accessories.
Details all controls and connectors located on the top panel of the transceiver.
Identifies and explains controls and indicators on the front panel.
Identifies and explains connectors and indicators on the rear panel.
Details the antenna connector, DC power jack, and external mic/speaker jacks.
Explains the function of volume, squelch, ANL, and RF power controls.
Describes the main display showing operating function and status.
Explains indicators like transmit, scan, lock, memory, and frequency status.
Explains the S/Battery and Priority indicators for signal and battery status.
Describes the keyboard layout and operation of FUNC, LIGHT, and PTT keys.
Details the procedure for receiving signals, including volume and squelch adjustment.
Explains how to transmit, including microphone use and display indicators.
Explains how to access secondary functions using the FUNC key.
Explains how to store frequencies into memory channels.
Explains how to recall frequencies stored in memory channels.
Explains how to switch between memory channel and dial modes.
Explains how to use the CALL key to quickly access memory channel 1.
Details how to perform a memory scan through stored frequencies.
Explains how to scan between frequency limits stored in memory channels.
Provides advice on monitoring frequencies before transmitting to avoid interference.
Recommends taking the transceiver to an ICOM dealer for service if problems occur.
To Next Page
