12
3
BASIC OPERATION
3
■ User set mode
You can “customize” the transceiver operation to suit your
preferences and operating style.
Entering the user set mode:
q Hold down [User Set Mode] for 1 second to enter the user
set mode.
w Push [User Set Mode] one or more times to select the
appropriate item. Then push [CH Up] or [CH Down] to set
the desired level or condition.
• Available set mode functions are Backlight, Beep,
Beep Level, SQL Level, Mic Gain, Battery Voltage,
Signal Moni and Lone Worker.
e Hold down [User Set Mode] for 1 second again to exit the
set mode.
■ Emergency Call
When [Emergency] is pushed for the specified time period*,
the emergency signal is transmitted once, or repeatedly, on
the specified emergency channel.
A repeat emergency signal is automatically transmitted until
the transceiver receives an acknowledgement signal, or you
turn the transceiver power OFF.
When no emergency channel is specified, the signal is
transmitted on the previously selected channel.
If you want to cancel the emergency call, hold down
[Emergency] again before transmitting the call.
If your transceiver is programmed for Silent operation, you
can transmit an Emergency call without the beep sounding
and the LED indicator lighting.
IMPORTANT: It is recommended to set an emergency
channel individually to provide the certain emergency call
operation.
* Depending on the presetting. Ask your dealer for details.
D NOTES
Depending on the presetting, the following functions are
automatically activated. Ask your dealer for details.
• Auto TX function
After the emergency call transmission, audio from the microphone
is automatically transmitted for a specified time period.*
• Auto RX function
After the emergency call transmission, the transceiver
stands by in the audible mode for the specified time period.*
To Next Page
Loading...
Need help?
General
