To Next Page

To Previous Page

New2001New2001

PREPARATION

MMSI code programming ■

The 9 digit MMSI (Maritime Mobile Service Identity: DSC self

ID) code can be programmed at power ON.

The code is programmed by using the HM-195.

This initial code setting can be performed only once.

After being set, it can be changed by only your dealer

or distributor. If your MMSI code has already been pro-

grammed, this programming is not necessary.

Hold down [PWR](Dial) to turn ON the power. q

 •Threeshortbeepssound,and“NODSCMMSI”isdisplayed.

Push [ENT] to start the MMSI code programming. w

 •Push[CLEAR]twicetocanceltheprogramming,andgotothe

normal operating screen. In this case, the transceiver cannot

make a DSC call. To program the MMSI code, turn OFF the

power, then turn it ON again.

Enter your MMSI code in the following manner: e

 •SelectadesirednumberusingDial,or[∫]/[√]/[Ω]/[≈].

 •Push[ENT]orDialtosetit.

 •Tomovethecursor,selecteitherarrow,“←” or “→,” then push

[ENT] or Dial.

Repeat step r e to enter all 9 digits.

After entering the 9 digit code, “FINISH” is automatically t

selected, and then push [ENT] or Dial to set it.

The “MMSI CONFIRMATION” screen is displayed. y

Enter your MMSI code again for confirmation. u

 •Enterinthesamemannerasstepse through t.

When your MMSI code programming is successfully com- i

pleted, the screen as shown below is brieﬂy displayed.

 •Afterthat,thenormaloperatingscreenisdisplayed.

The programmed MMSI code can be checked in the MENU

screen.

NOTE: Depending on the transceiver version, the ATIS

code programming may be required after programming the

MMSI code. See the next page for details.

Icom IC-M400BB User Manual

Other manuals for Icom IC-M400BB