• Disconnect this equipment from mains supply before cleaning. Don’t use liquid or sprayed detergent for cleaning.
Use moisture sheet or cloth for cleaning.
• Before opening the device, first switch it off and then disconnect the power plug. Observe the specification in the
user manual.
• The warranty will be invalidated if the device is damaged during the installation or replacement of system
expansions.
• Lay this equipment on a reliable surface when installed. A drop or fall could cause injury.
• Make sure power adapter and power cord are placed in a way that people cannot step on them. Do not place
anything over the power adapter or power cord.
• All cautions and warnings on the equipment should be noted.
• If the equipment is not used for long time, disconnect the equipment from mains supply to avoid being damaged
by transient overvoltage.
• Make sure that no objects or liquids get inside the device (danger of electric shock, fire, short circuit).
• If one of the following situations occurs, get the equipment checked by a service personnel:
o The power adapter, power cord or plug is damaged.
o Liquid has penetrated into the equipment.
o The equipment has been exposed to moisture.
o The equipment does not work well or you cannot get it work according to user manual.
o The equipment has been dropped or damaged.
o The equipment has obvious signs of breakage.
• Do not leave this equipment in an unconditioned environment. Storage temperature below -20 °C (-4 °F) or above
60 °C (140 °F) may cause damage of the equipment.
• Do not use this equipment in an unconditioned environment. Unless otherwise stated in the technical
specifications operational conditions may not exceed the following limits, it may damage the equipment:
o Vertical usage:
Temperature: 0 °C to 35 °C, 32 °F to 104 °F
Humidity: 10 % to 80 %, non-condensing
o Horizontal usage (only with optional rubber feet, no VESA mount):
Temperature: 0 °C to 35 °C, 32 °C to 95 °F
Humidity: 10 % to 80 %, non-condensing
• Note that even in closed rooms local temperatures may increase, for instance in case the device is exposed to
strong sun radiation. Protect the device from external heat sources.
• Ensure that air is free to circulate through the product. Do not use in a poorly ventilated place. Do not cover it
with a cloth or place it on soft ground. Surrounding objects of the device may block the air flow. Keep a minimum
distance of 20 cm around the device for sufficient ventilation.
• Horizontal usage with optional rubber feet: Tilt the housing to the left so that the power button is one the left-
hand side:
To Next Page
Loading...
Need help?
General
