Before using for the rst time
Before using the coffee/tea maker for the rst
time, wash, rinse and dry carefully.
How to use the coffee/tea maker
1 Hold the coffee/tea maker rmly and pull
the plunger (a) straight up and out of the
pot (b). Preferably, preheat the pot by
rinsing it with hot water.
2 Add tea or coarsely-ground coffee into the
pot. Use amount of tea or coffee according
to taste. Recommendation: Calculate 1
tablespoon of coffee per decilitre of water
(NA: 1 tablespoon/cup).
3 Fill up with hot water. Always leave a
minimum of 5 cm/2 in. of space at the
top of the pot (ca. 2.5 cm/1 in. below the
spout). See g. 1.
4 Stir.
5 Place the plunger on top of the pot so that
the lid ts tight (the arrow on the lid should
not point to the spout). Do not press the
plunger down into the pot! See g. 2.
6 Let the coffee/tea draw for about 4 minutes.
7 Hold the coffee/tea maker rmly with the
spout turned away from you. Lower the
plunger slowly and carefully into the pot.
For best result, apply slight pressure. If the
lter clogs or it becomes difcult to push
down the plunger: Remove the plunger from
the pot, stir the brew and then slowly press
the plunger down again.
8 Turn the lid to open the pour spout and then
pour coffee/tea from the pot and serve. See
g. 3.
Cleaning
The coffee/tea maker is dishwasher-safe.
Important!
Do not place the coffee/tea maker directly on
a source of heat.
ENGLISH 4
To Next Page
Need help?
General
