ENGLISH 19
After unpacking the oven, make sure that
it has not been damaged during transport
and that the oven door closes properly. In
the event of problems, contact the dealer or
your nearest After-sales Service. To prevent
any damage, only remove the oven from
its polystyrene foam base at the time of
installation.
Preparing the housing unit
Kitchen units in contact with the oven •
must be heat resistant (min 90°C).
Carry out all cabinet cutting work before •
tting the oven in the housing and
carefully remove all wood chips and
sawdust.
After installation, the bottom of the oven •
must no longer be accessible.
For correct appliance operation, do •
not obstruct the minimum gap between
the worktop and the upper edge of the
oven.
General recommendations
Before use
Remove cardboard protection pieces, -
protective lm and adhesive labels from
accessories.
Remove the accessories from the oven -
and heat it at 200° for about an hour
to eliminate the smell and fumes from
the insulating materials and protective
grease.
During use
Do not place heavy objects on the door -
as they could damage it.
Do not cling to the door or hang -
anything from the handle.
Do not cover the inside of the oven with -
aluminium foil.
Never pour water into the inside of a -
hot oven; this could damage the enamel
coating.
Never drag pots or pans across the -
bottom of the oven as this could damage
the enamel coating.
Make sure that the electrical cables of -
other appliances do not touch hot parts
of the oven or become trapped in the
door.
Do not expose the oven to atmospheric -
agents.
Installation
To Next Page
Loading...
Need help?
General
