4ENGLISH
The worktop is made of melamine laminate
pressed onto particleboard. Melamine
laminate is made by pressing melamine-
resin-impregnated paper together. Applying
pressure with heat hardens the surface
and, when cooled down, a permanent and
durable plastic nish is the result.
Melamine laminate is used for surfaces that
need to withstand daily wear and tear for a
long time. Alterations are not recommended,
except where cutting the worktop is
necessary for installation, and additional
edge covering is supplied with the product.
Advice for use:
Before installation
• Before installation, store the worktop in a
room with normal temperature and humidity
levels. Do not place the worktop against a
warm radiator, or lay it on a cold oor.
• When storing the worktop, stand it on the
back edge of its long-side.
• Do not open the plastic package until you
are ready to install the worktop.
• Supporting legs are required when an
overhang exceeds 25 cm. The maximum
distance between these legs should not be
more than 80 cm.
• Worktops that are installed above a
dishwasher, washing machine or oven should
be protected on the underside with FIXA
diffusion barrier.
• Not suitable for use in wet rooms.
• Only recommended for indoor use.
To Next Page
Loading...
Need help?
General
