What to do if...
Problem Possible cause Remedy
There is no spark when light-
ning the gas.
There is no electrical supply. Check that the unit is plug-
ged in and the electrical
supply is switched on.
There is no electrical supply. Check the house electric in-
stallation fuse.
Burner cap and crown are
placed incorrectly.
Check if the burner cap and
crown have been replaced
correctly, e.g. after cleaning.
The flame is blowing out im-
mediately after lightning.
Thermocouple is not heated
enough.
After lightning the flame,
keep the knob pushed for
about 5 seconds.
The gas ring burns unevenly. Burner crown is blocked with
food residues.
Check if the main injector is
not blocked and the burner
crown is clear of food parti-
cles.
If there is a fault, first try to find a solution to
the problem yourself. If you cannot find a
solution to the problem yourself, contact the
After Sales Service.
If you operated the appliance
wrongly, or the installation was
not carried out by a registered
engineer, the visit from the
customer service technician or
dealer may not take place free
of charge, even during the
warranty period.
Technical data
Hob dimensions
Width 580 mm
Depth 500 mm
Built in height 34 mm
Other technical data
Class Appliance: 3
Appliance Category: II2H3+
Appliance gas supply: Natural
gas G20 (2H) 20 mbar
This appliance is designed for
use with natural gas but can be
converted for use with other gas
type according to table below.
ENGLISH 12
To Next Page
Loading...
Need help?
General
