IKEA LAGAN Installation Instructions

12
Use pressure regulators suitable
for the gas pressure indicated
in the Instruction.
- The gas nozzles must be
changed by After Sales Service
or a qualified technician.
- Nozzles not supplied with the
appliance must be ordered
from After Sales Service.
- Adjust the minimum setting of
the taps.
NOTE: when liquid petroleum gas is
used (G30/G31), the minimum gas
setting screw must be tightened as far
as it will go.
IMPORTANT: should you experience
difficulty in turning the burner knobs,
please contact the After Sales Service
for the replacement of the burner tap if
found to be faulty.
Replacing the injectors
(see paragraph “injector table”)
- Remove grids (A).
- Extract burners (B).
- Using a spanner of the
appropriate size unscrew the
injector (C), unscrew the
injector to be replaced.
- Replace it with the
injector suitable for the
new type of gas.
- Re-assemble the injector in (D).
Before installing the hob,
remember to affix the gas
calibration plate supplied with
the injectors in such a way
that it covers the existing
information relating to gas
calibration.
Adjusting minimum gas setting of
taps
To ensure that the minimum setting is
correctly adjusted, remove the knob (E)
and proceed as follows:
- tighten screw to reduce the
flame height (-);
- Loosen screw to increase the
flame height (+).
The adjustment must be performed
with the tap in minimum gas setting
position (small flame).
- The primary air of the burners
does not need to be adjusted.

IKEA LAGAN Specifications

General

Brand	IKEA
Model	LAGAN
Category	Dishwasher
Language	English