IMPORTANT SAFETY INSTRUCTIONS
For indoor use only.
Regularly check the cord, the transformer and all other parts for damage. If any part is damaged the product should
not be used. Important information! Keep these instructions for future use.
CAUTION!
The light source of this product is non-changeable light diodes (LED).
Do not disassemble the product, as the light diodes can cause damage to the eyes.
Do not immerse in water.
Cleaning:
Use a damp cloth, never a strong cleaning agent.
To reduce the risk of fire, electric shock, or injury to persons: Use only insulated staples or plastic ties to secure
cords. Route and secure cords so that they will not be pinched or damaged when the cabinet is pushed to the wall.
Position the portable cabinet light with respect to the cabinet so the lamp replacement markings can be read during
relamping. Not intended for recessed installation in ceilings, or soffits. The low-voltage portable cabinet light may be
installed inside or under a kitchen cabinet or other built-in furniture when:
1. The low-voltage Class 2 power supply is located outside the cabinet and is not concealed; and
2. The line voltage power supply cord is not concealed or run through openings in the cabinet, walls, ceilings, or
floors. This requirement does not apply to the wiring between the cabinet light and the power unit. The National
Electric Code (NEC) does not permit cords to be concealed where damage to insulation may go unnoticed. To
prevent fire danger, do not run cord behind walls, ceilings, soffits, or cabinets where it may be inaccessible for
examination. Cords should be visually examined periodically and immediately replaced when any damage is
noted.
ATTENTION:
Injury to persons and damage to the lamp and/or the mounting surface may result if the lamp is pulled from the
surface. To reduce the likelihood of such injury or damage, mount only on a surface that is mechanically sound.
Use only IKEA LED drivers suited for this product. The total wattage of the lamps connected to one LED driver must
not exceed the maximum power stated on that LED driver and never more than 30W.
WARNING: Deviation from the assembly instructions may result in a risk of fire or electric shock.
To Next Page
Loading...
Need help?
General
