13
Installation and fixing
The installer is responsible for any damage or
injury resulting from incorrect installation.
To guarantee correct operation, the appliance
must be installed on a perfectly flat surface.
If necessary, cut the kitchen unit and worktop to fit before
installing the hob. Clean the cutout of any chips that could
compromise appliance operation.
For
flush mounted installation or setting into
a marble worktop
, contact the After-sales
Service for the installation kit and necessary
instructions.
• 4812 310 19277 Installation kit for marble
worktop.
• 4801 211 00112 Installation kit for flush fitted
worktop.
To guarantee correct operation, the appliance must be
installed on a perfectly flat surface.
If necessary, cut the kitchen unit and worktop to fit before
installing the hob. Clean the cutout of any remaining dust
that could compromise appliance operation.
For the distance between the underside of the induction
hob and the kitchen unit (or separating panel), observe the
dimensions given in the figure at the side. If a column unit
is installed adjacent to the hob, leave a distance of at least
100 mm from the edge of the hob.
Undercounter oven installation:
•
If an oven (which must be of our manufacture) is to be
installed under the hob, ensure it is equipped with a
cooling system and observe the distances given in the
figure to the side.
•
There must be nothing between the hob and the oven
(cross rails, panels, brackets, etc.).
min.
To Next Page
Loading...
Need help?
General
