Problem Possible cause Solution
The dishes are
wet and dull
No rinse aid has been used. Set the rinse aid dosage.
The rinse aid dispenser is empty. Fill the rinse aid dispenser.
There are
streaks, milky
spots or a blu-
ish coating on
glasses and
dishes
Wrong dosage of rinse aid. Decrease the rinse aid dosage.
Dry water
drop signs on
glasses and
dishes
Wrong dosage of rinse aid. Increase rinse aid dosage.
The detergent can be the cause. Use different type of detergent.
Technical data
Dimensions Width (cm) 44,6
Height (cm) 81,8-89,8
Depth (cm) 55,0
Water supply pressure
1)
Minimum
Maximum
0,5 bar (0,05 MPa)
8 bar (0,8 MPa)
Capacity (place settings) 9
Energy class A
Washing class A
Drying class A
Noise (dB(A)) 50
Average annual energy con-
sumption (kWh)
2)
176
Average annual water con-
sumption (litres)
2)
2860
1) If the pressure in your area is lower or higher, please contact your After Sales Service.
2) The data is based on the washing programme for test institutes assuming 220 cycles per a year.
Information on the electrical connection, voltage and overall power is given on the rat-
ing plate on the inner edge of the dishwasher door.
Installation
Caution! Refer to the assembly
instructions, in order to proceed with the
installation.
Warning! Make sure that mains plug is
disconnected from the mains socket
during installation.
ENGLISH 18
To Next Page
Loading...
Need help?
General
