You must set the water softener man-
ually and electronically.
Manual adjustment
The appliance is set at the factory at posi-
tion 2.
1
2
Set switch to posi-
tion 1 or 2.
Electronic adjustment
The water softener is set at the factory at
level 5.
1. Switch on the appliance.
2. Make sure that the appliance is in set-
ting mode.
3. Press and hold the programme selec-
tion/cancel button.
4. Release the programme selection/can-
cel button when programme indicator
light A starts to flash and programme
indicator light B comes on.
5. Wait until programme indicator light B
goes off.
– Programme indicator light A starts to
flash.
– The end indicator light starts to flash.
6. Press the programme selection/cancel
button one time.
– Programme indicator light A starts to
flash.
– The setting function of the water soft-
ener is activated.
– The end indicator light flashes to
show the level of the water softener.
Example: 5 flashes, pause, 5 flashes,
pause, etc... = level 5.
7. Press the programme selection/cancel
button one time to increase the water
softener level by one step.
8. Press the on/off button to save the op-
eration.
Use of dishwasher salt
Caution! Only use dishwashers salt.
Types of salt that are not applicable
for dishwashers cause damage to the water
softener.
1
2
3
Fill the salt contain-
er with 1 litre of wa-
ter (only the first
operation).
4
Fill the salt contain-
er with 1,5-2,0 kg of
salt. Use the salt
funnel supplied.
ENGLISH 10
To Next Page
Need help?
General
