5
knife back and forth. Bear in mind
that it is important to not apply
too much pressure on the knife,
as this can damage the wheels.
Move the knife to the second slot
and repeat the procedure. Finally
place the knife in the third slot to
ne tune the edge. Pull the knife
through each slot about 15-20
times.The number of strokes
required will depend on the
material and the condition of the
knife. If the knife is still not sharp
enough, start over with the rst
slot and repeat all three steps.
Clean the sharpener by running it
under cold water. When the knife
has been sharpened it needs to
be cleaned before use.
To Next Page
Loading...
Need help?
General
