INTRODUCTION
Congratulations on the purchase of this IMPULSE SD-Series Amplier.
Rest assured you have purchased a quality product designed and enginee-
red to give you many years of uncompromised musical service. This amp-
lier has been designed using the latest in electronic technology available
today and will provide you with years and years of high quality sound level
amplication and reproduction.
This amplier has been designed with a fully regulated MOS-FET Power
supply assuring extremely quick switching response and self protection with
soft starting power turn on.
PROTECTION CIRCUITRY
Advanced protection circuits have been designed into all our ampliers.
The protection circuits will disable the ampliers if it senses an input over-
load, speaker short circuit or extreme high temperature conditions.When
the protection circuit is in operation the amplier will go into a selfpreserva-
tion mode. At this time please check your system to see what is causing the
protection circuit to re. The amplier can be reset by turning the remote
power off and then on again. If the system shuts down because of the ther-
mal overload condition, allow the amplier to cool down before restarting.
If the amplier shuts down because of an input overload or speaker short
circuit please be sure to correct these conditions before
restarting the amplier.
WE WANT YOU LISTENING FOR A LIFETIME
Used wisely, your new sound equipment will provide a lifetime of fun and
enjoyment. Since hearing damage from loud noise is often undetectable
until it is too late, we recommend you to avoid prolonged exposure to ex-
cessive noise.
To Next Page
Need help?
General
