9
www.insigniaproducts.com
12-Cycle Electric and Gas Dryers
INSTALLATION INSTRUCTIONS
Control panel
# ITEM DESCRIPTION
1
Cycle
selector
Turn to select the cycle for the type of load. The cycle you select
determines the heat control for the cycle. The Normal, Heavy Duty,
Towels, Casual, Delicates, and Sanitize cycles are Sensor Dry cycles.
The Quick Dry, Time Dry (20M, 40M, 60M, 80M), and Air fluff cycles
are Manual Dry cycles. For more information, see Dryer options and
settings on page 37.
2
Cycle
status
display
The Drying, Cooling, and Wrinkle Care (process) indicators flash to
show which step of the dry cycle you are in.
The Clean Filter indicator flashes 10 times when the dryer is turned
on to remind you to clean the filter.
The Wrinkle Care (option) indicator lights up when you turn on the
setting.
3
Power
Press to turn your dryer on or off. If your dryer is on and idle for more
than 10 minutes without any buttons being pressed, it automatically
turns off.
4
Dry
Temp.
Press repeatedly to select the drying temperature.
• High: For sturdy cottons or those labeled Tumble Dry.
• Med: For permanent press, synthetics, lightweight cottons, or
items labeled Tumble Dry Medium.
• Low: For lower heat than Medium to dry synthetic or washable
knit fabrics.
• No Heat: Provides just the air cycle without any heat.
5
Wrinkle
Care
Press and hold Dry Temp. and Dryness for three seconds to add the
Wrinkle Care step. Press again to cancel. Wrinkle Care provides
approximately 90 minutes of intermittent tumbling in unheated air at
the end of the cycle to reduce wrinkling. The load is already dry and
can be removed at any time during the Wrinkle Care cycle.
6
Dryness
Press to select the dryness level. Different dryness levels result in
different drying times. For clothes to be ironed manually, select a
lower dryness level. For more information, see Dryer options and
settings on page 37.
7
Start/
Pause
Press to start or pause the drying cycle. When you pause the cycle,
you can add items to the dryer, but your cannot change any settings.